Por favor, use este identificador para citar o enlazar este ítem: http://hdl.handle.net/11531/100547
Registro completo de metadatos
Campo DC Valor Lengua/Idioma
dc.contributor.authorSáenz Nuño, María Anaes-ES
dc.contributor.authorPuente Rueda, Cristinaes-ES
dc.contributor.authorRubio Alvir, Eva Maríaes-ES
dc.date.accessioned2025-07-10T14:20:46Z-
dc.date.available2025-07-10T14:20:46Z-
dc.date.issued2025-06-01es_ES
dc.identifier.issn2079-6412es_ES
dc.identifier.urihttps:doi.org10.3390coatings15060624es_ES
dc.identifier.urihttp://hdl.handle.net/11531/100547-
dc.descriptionArtículos en revistases_ES
dc.description.abstractes-ES
dc.description.abstractLaser engraving is a widely used technique for bamboo applications. However, the literature lacks a recommended standard roughness parameter or a numerical comparison between samples for a quantitative assessment of surface texture post-engraving. In this research, we systematically evaluated well-known 2D roughness parameters typically used for metal parts and measured them for laser bamboo engraving under various laser conditions. We utilized a pulsed laser with a 450 nm wavelength and 5.5 W power to engrave bamboo specimens, examining the surface roughness at different speed and power combinations. We utilized all available parameters with calibrated equipment to compare the results and identify the most relevant ones for characterizing the final texture with sufficient resolution for bamboo specimens. Unlike existing studies, which were limited by testing materials and laser conditions, we propose only two 2D measurement parameters that can be evaluated and compared across different materials and engraving lasers, not just under specific conditions. These selected combinations of R and P parameters can determine the quality of the engraved surface with a single measurement. In this paper the Rz parameter is proposed as the quantitative parameter to characterize the engraving.en-GB
dc.language.isoen-GBes_ES
dc.sourceRevista: Coatings, Periodo: 1, Volumen: online, Número: 6, Página inicial: 624-1, Página final: 624-35es_ES
dc.subject.otherInstituto de Investigación Tecnológica (IIT)es_ES
dc.titleThe Characterization of Surface Texture in Laser Bamboo Engraving: A Metrological Approaches_ES
dc.typeinfo:eu-repo/semantics/articlees_ES
dc.description.versioninfo:eu-repo/semantics/publishedVersiones_ES
dc.rights.holderes_ES
dc.rights.accessRightsinfo:eu-repo/semantics/openAccesses_ES
dc.keywordses-ES
dc.keywordslaser bamboo engraving; roughness set up; surface texture characterizationen-GB
Aparece en las colecciones: Artículos

Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
IIT-25-157R10,51 MBUnknownVisualizar/Abrir
IIT-25-157R_preview3,01 kBUnknownVisualizar/Abrir


Los ítems de DSpace están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.