Por favor, use este identificador para citar o enlazar este ítem:
http://hdl.handle.net/11531/76752
Título : | Numerical analysis of thermomechanical phenomena influencing tool wear in finishing turning of Inconel 718 |
Autor : | Soldani, Xavier Miguélez, María Henar Cantero Guisández, José Luis Díaz Álvarez, José |
Fecha de publicación : | 18-mar-2014 |
Resumen : | . Inconel 718, one of the most used Ni alloys, is a low machinability material due to the elevated stresses and temperatures generated at the cutting edge during machining related to aggressive tool wear. The understanding of thermo-mechanical phenomena involved during cutting is required for enhancement of wear performance. In this work a three dimensional (3D) numerical model based on finite element (FE) is applied for simulation of dry turning of Inconel 718. Despite the elevated computational cost, 3D modeling is required for analysis of wear mechanisms. The model was validated with turning tests. Main wear modes experimentally identified (chipping, notching, built up edge BUE) were related to variables predicted using the numerical model, such as temperature and plastic strain at the chip. Good correlation between experiments and numerical results was observed, and strong influence of the side cutting edge in wear performance was found. |
Descripción : | Artículos en revistas |
URI : | https://doi.org/10.1016/j.ijmecsci.2014.03.010 http://hdl.handle.net/11531/76752 |
ISSN : | 0020-7403 |
Aparece en las colecciones: | Artículos |
Ficheros en este ítem:
Fichero | Tamaño | Formato | |
---|---|---|---|
202212229499228_1-s2.0-S0020740314000861-main.pdf | 3,19 MB | Adobe PDF | Visualizar/Abrir |
Los ítems de DSpace están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.